Cooking appliances · Boston, MA
Wolf Cooktop Repair
Gas, induction and electric Wolf cooktops, including the drop-in units common in Boston island renovations. Faults range from spark and valve problems on gas to failed zones, fault codes and cracked glass on induction and radiant tops.
Word for word
What gets described on the phone
- One induction zone dropping out under a full pan
- Igniters firing on every burner at once
- Sealed burner flame lifting away from the port
- Fault code returning shortly after a reset
Gas, induction and radiant — including cracked glass and fault codes.
On the visit
What actually gets measured
- Inverter temperature and cooling airflow on induction, under a loaded pan
- Spark electrode gap and the condition of its porcelain on gas
- Flame pattern and colour at full and at simmer
- Fault codes read out and cross-checked against zone behaviour
Cost
The ranges this work falls into
Three things set the figure: which part failed, whether it is on the van or has to be ordered for the platform, and how much has to come apart to reach it. A spark module behind a control pod and an infrared broiler assembly are not the same afternoon — so these are bands, and your number is quoted after the diagnosis and before anything is opened.
- Igniter or spark module replacement $290–$680
- Burner valve or orifice service $260–$1,050
- Oven thermostat or sensor calibration $140–$730
- Convection fan or motor $330–$910
- Control board or touch panel $510–$1,590
- Door hinge, glass or seal $200–$920
Flat $95 service call covering the visit and full diagnosis, credited against the repair once you approve it.
The other half of the decision is what a replacement costs. A comparable new pro range runs $6,350–$19,170 for the unit alone, before delivery, hookup, gas or electrical work and the cabinetry that almost always comes with it. That is why a control board is usually still the cheaper answer.
Reviews
On wolf cooktop repair in particular
4.9
5 out of 5
Igniters were firing on every burner at once, all night if we let them. A spill had got right into the switch bank. Dried out, part replaced, quiet ever since.
Malachy P.West Roxbury
5 out of 5
The flame was lifting away from the port and blowing itself out. Wrong orifice from an earlier install, plus a partly blocked port. He corrected both and checked the pressure at the manifold.
Rosalind F.Charlestown
5 out of 5
A fault code came back within a day of every reset. He did not simply clear it again, he traced a failing temperature sensor under the glass and replaced it. Two weeks on and no code.
Terrence B.South Boston
Book a visit
Tell us the model and the fault. The figure follows.
A flat $95 service call covers the visit and the diagnosis, and comes off the bill when you approve the repair. Visits run 8:00 am – 8:00 pm, seven days; the line is answered 24/7.
